User Manual

ARTURIA – DrumBrute – USER’S MANUAL 21
2.7 Rear panel, part 2
1. Individual Outs (see 2.7.1)
2. Metronome Output (see 2.7.2)
3. Mix Output (see 2.7.3)
4. Headphone Level Control (see 2.7.4)
5. Headphone Outputs (see 2.7.5)
2.7.1 Individual Outs
Each DrumBrute instrument channel has a dedicated 3.5mm output jack on the rear
panel. Both instruments of a shared channel will share that channel’s output.
When a cable is connected to one of the individual outputs, that instrument channel will
be removed from the Mix Output. This is true for the Metronome output as well.
The output level of each instrument channel is set by the corresponding Level knob on
the front panel.
2.7.2 Metronome Output
The metronome has its own individual output because the metronome’s output circuitry
behaves in a slightly different manner than the other instruments. See section 2.7.5 for
details.
2.7.3 Mix Output
This output jack carries the output signal for every instrument channel. When a cable is
connected to one of the individual outputs, that instrument channel will be removed from
the Mix Output. This is true for the Metronome output as well.
The Mix Output level is controlled by the Master Volume knob on the front panel.
2.7.4 Headphone Level Control
This knob is recessed into the rear panel to avoid an accidental change in level. Push the
knob inward to release it for adjustment, and push it back in to protect it from further
changes.