User Manual

58 ARTURIA – DrumBrute – USER’S MANUAL
Sending an edited Template to DrumBrute (not synced)
10.3.3 Send one pattern to DrumBrute
10.3.3.1 When synced
Important: The following process will send a single pattern to DrumBrute and will
overwrite the pattern in the target memory location.
There are two ways to send a single pattern to the DrumBrute when it is synced to the
MIDI Control Center.
First use the +/- buttons in the Local Templates window to open the Template and locate
the pattern you want to send. Then you can do one of two things:
• drag the pattern on the Working Memory. It will be sent into the DrumBrute at
the same pattern location as the source pattern (i.e., #1 will go to #1)
• drag the selected pattern to one of the 16 pattern tabs in the Editor window. That
way you can specify exactly which pattern location in the DrumBrute will receive
the pattern. This can only be done within the selected bank tab, though.
10.3.3.2 When not synced
Important: The following process will send a single pattern to DrumBrute and will
overwrite the pattern in that memory location.
If you’d like to transfer only one pattern from a Template to the DrumBrute, find that
pattern in the Local Templates window and drop it onto the Working Memory. This will
send the selected pattern directly into the DrumBrute at that same pattern location.
In the example below, pattern #1 from Bank A of the “A Big Gig” Template will overwrite
pattern #1 in Bank A of the DrumBrute internal memory.