User Manual

68 ARTURIA – DrumBrute – USER’S MANUAL
10.9 Device Settings
The Device Settings tab on the upper right side of the MIDI Control Center window
contains essential parameters that enable you to optimize DrumBrute for your setup and
your working style.
10.9.1 MIDI Channel
Use the pull-down menu to select the Global MIDI Channel for DrumBrute.
10.9.2 Global settings
We’ll go through the Global settings left to right and top to bottom.
10.9.2.1 Clock In/Out Settings
This is where you determine which clocking signal will be transmitted and recognized by
the Clock input and output connectors. Settings: 1step, 2PPQ (Korg), 24 PPQ, and 48
PPQ.
10.9.2.2 Auto-Sync
This parameter tells the DrumBrute what to do if it is not running and it receives a clock
signal from an external source. When Auto-Sync is On the unit will respond to the first
clocking signal it receives, and when the clock signal stops the DrumBrute will switch to
Internal clock.
When Auto-sync is Off the DrumBrute will wait until it receives a signal from the front
panel Sync selection.
10.9.2.3 Tap Tempo
Choose whether it will take 2, 3, or 4 taps to set the Tempo.
10.9.2.4 Global BPM
This parameter allows you to override the independent Tempo settings of each pattern.
When set to Global each pattern will play at the current Tempo value on the front panel.
10.9.2.5 Wait to Load Pattern
With this parameter you can specify whether a new pattern will be loaded as soon as you
select it or not. If not, DrumBrute will wait until the end of the current pattern before
switching to the next one.
10.9.2.6 Accent Velocity Threshold
This sets the MIDI velocity value for the Accents you add when editing a pattern.