User Manual

7.2. As Slave
DrumBrute functions as a slave to an external clock when one of the other three Sync LEDS
are lit (USB, MIDI or CLK). When DrumBrute is in Slave mode:
• The Tempo controls will not control the internal sequencer while the external
source is running.
• The DrumBrute transport section will work the same way: you can still stop, start
and pause the internal sequencer, and you can still record patterns.
• DrumBrute will pass the synchronization messages it receives from the external
source to its USB, MIDI and Clock outputs.
7.2.1. Clock In/Out rates
The MIDI Control Center can be used to configure DrumBrute to send and receive one of the
following clock signals at the Clock input and output connectors:
• 1step (one pulse per step , or pps)
• 2PPQ (Korg Volca standard)
• 24PPQ (standard DIN sync)
• 48PPQ
The default rate is 24PPQ.

Note: it is better to synchronize the Drumbrute with 48ppqn. The synchronisation will be more
accurate. 1pps and 2ppqn are not advised, unless really necessary.
7.2.2. Clock connectors
There are several types of connectors that have been used for musical synchronization
purposes over the years. Here’s a chart that indicates the best kinds to use when connecting
older devices to DrumBrute:
Connector type Signal(s) sent
1/8’’ mono (TS) Clock pulse only
1/8’’ stereo (TRS) Clock pulse and start/stop
Check the owner’s manual for your device if you are not sure which sort of sync capabilities
it has.
Arturia - User Manual DrumBrute - Synchronization 52