User Guide / Owners Manual

ARTURIA – Matrix-12 V – USER MANUAL 42
The VCO1 and Filter parameter groups
In the pictures above the Frequency, Detune, Pulse Width, waveform and Volume
parameters are all part of the VCO1 parameter group. Likewise, the Filter frequency,
Resonance, Mode, and both VCA settings are part of the Filter parameter group.
Here’s a list of all the parameter groups in Single mode:
Name
Parameters
VCO 1
Freq, detune, PW, waveform, volume
VCO 2
Sync, freq, detune, PW, waveform,
volume
FM
Amplitude, destination
Filter
Freq, res, mode, VCA 1 level, VCA 2
level
Lag
Input, rate, mode switches
Ramps
Rate control (x4)
Env
Delay, attack, decay, sus, rel, amp (x5)
Track
Input, track point levels 1-5 (x3)
LFO
Speed, wave, input, retrig, amp (x5)
Many of those parameter groups have additional “members” that are available
when you press the Page 2 button.
4.1.1.2 Tabs
The next level of organization are the tabs inside certain parameter groups. For
example, you can only see one envelope, tracking generator, and LFO at a time,
but the tabs beneath the blue bars alert you to the fact that there are more than
one of these parameter groups available.
Case in point: look at the parameter group ENV, where there are 5 tabs labeled
ENV1, ENV2, etc. This means there are 5 envelopes available for programming a
Voice.