User Guide / Owners Manual

ARTURIA – Matrix-12 V – USER MANUAL 56
Let’s go through all of the other LFO group parameters now:
Speed: Controls the rate of the LFO waveform, except for Noise.
Input: Only available when LFO Wave is set to Sample, with 27 source options.
Retrig: Allows you to specify the starting point of the LFO for the first five waveforms.
A setting of 0 means the LFO will start from the beginning of its cycle, while values of
1 or higher will cause the LFO to be triggered from somewhere in the middle of its
cycle.
Amp: Determines the overall LFO output that will be sent to the target.
Press the Page 2 button for the final two parameters in the LFO group:
Lag: The LFO Lag parameter can be used to round off the edges of the LFO
waveform. This will be most noticeable when using a Square wave LFO and least
noticeable when using the Triangle waveform. It is actually not related to the Lag
processor and has a predetermined impact. If a greater Lag effect is desired, the
LFO can be routed through the Lag processor directly and then routed to the VCO
through the Modulation Page.
Retrig Mode: Selects single or multiple trigger response. “Off” provides the LFO with
a “freerun” setting.
Remember to use the Tabs to select LFOs 1-5, and the the mod buttons will bring
their parameters into focus in the Modulation Page so you can create one or more
mod routes.
4.3 The Effects
To add one of the effects to a Matrix-12 V sound in Main mode, click the FX button
in the nameplate:
The bottom panel will reveal two drop-down menus, either of which will show you
the available Effects choices when you click the words “SELECT EFFECT”:
Make a selection and its FX module will appear in the bottom panel, either on the
left half or the right, depending on which one you chose.