User Guide / Owners Manual

ARTURIA – Matrix-12 V – USER MANUAL 59
4.3.3 Analog Delay
Delay: Sets the delay time. (The delay is mono for authenticity.)
FB Tone: Changes feedback filtering
FB Amount: Adjusts Feedback
LFO Depth: Sets the amount of delay time modulation (which follows a sine wave)
LFO rate: Controls the modulation rate
Mix: Alters wet/dry mix
This analog-style delay reproduces the sound of the old solid state units that used
analog bucket brigade circuits. The Delay knob allows you to select a time between
4.5ms and 1000ms. The Feedback Amount knob sets the feedback level. The Tone
knob controls a feedback filtering effect: low-pass to the left, high-pass to the right.
You can set the delay modulation by changing the LFO rate and LFO depth values.
The Wet/Dry slider sets the ratio between the original and modified signals.
4.3.4 Flanger
Delay: Sets the delay time, which changes the harmonic content.
Depth: Sets the modulation depth. This is set to “max out” at less than 100% to limit
runaway feedback.
Rate: Sets the modulation rate for the delay time.
Feedback: Adds positive or negative feedback for a harsher or "ringing" sound.
Double-click this control or set it to the 12:00 position for zero feedback.