User Manual
Table Of Contents
- User Manual
- Special thanks
- Introduction
- Table Of Contents
- History of the original instrument
- ACTIVATION AND FIRST START
- USER INTERFACE
- THE SYNTHESIZER
- THE BASICS OF SUBTRACTIVE SYNTHESIS
- A FEW ELEMENTS IN SOUND DESIGN
- END USER LICENSE AGREEMENT
You will notice that the sound is particularly linear and without life.
The sawtooth signal from the first oscillator goes through a filter where the cut-off
frequency is set to the maximum.
This minimalist configuration will let you easily perform some simple experiments with this
basic sound.
Start by changing the waveform of this oscillator to appreciate some of the tones it can
produce.
Progressively lower the cut-off frequency of the low pass filter. The sound becomes more
and more “damp”.
Change the range of the oscillator with the “range” knob (as a default it is set to 8’). In this
case, lower it to 16’.
Change the waveform of oscillator1
Lower the cut-off frequency of the low
pass filter
71 Arturia - User Manual Mini V - A FEW ELEMENTS IN SOUND DESIGN