User`s manual

4.2.6.3 Clock
The Clock switch sets the LFO rate’s operating mode. It can be slaved
to the Sequencer tempo clock (Seq) or set to Free mode (i.e., the LFO
rate depends solely on the Rate knob setting).
4.2.6.4 Modulation routing
PWM & Metalizer
The PWM & Metalizer knob controls the amplitude and polarity of the LFO
signal that modulates the oscillator pulse wave Pulse Width, and the
Metalizer’s folding level. At the 0 position (12 o'clock) no modulation is
sent to the targets. When turned counter-clockwise (below the 0 mark)
the PWM & Metalizer knob sends an increasing amount of the inverted LFO signal.
When turned clockwise (beyond the 0 mark) the PWM & Metalizer knob sends an
increasing amount of the normal LFO signal.
Pitch
The Pitch knob controls the amplitude and polarity of the LFO signal
that modulates the oscillator pitch. At the 0 position (12 o'clock) no
modulation is sent to the targets. When turned counter-clockwise
(below the 0 mark) the Pitch knob sends an increasing amount of the
inverted LFO signal. When turned clockwise (beyond the 0 mark) the Pitch knob
sends an increasing amount of the normal LFO signal.
Filter
The Filter knob controls the amplitude and polarity of the LFO signal that
modulates the filter’s cutoff frequency. At the 0 position (12 o'clock) no
modulation is sent to the target. When turned counter-clockwise (below
the 0 mark) the Filter knob sends an increasing amount of the inverted
LFO signal. When turned clockwise (beyond the 0 mark) the Filter knob sends an
increasing amount of the normal LFO signal.
Amp
The Amp knob control the amplitude and polarity of the LFO signal
that modulates Amplifier’s level. On the 0 position (12 o'clock) no
modulation is sent to the target. When turned counter-clockwise
(below the 0 mark) the Amp knob sends an increasing amount of the
inverted LFO signal. When turned clockwise (beyond the 0 mark) the Amp knob
sends an increasing amount of the normal LFO signal.
Arturia MiniBrute SE User's Manual 37 4 General description