User Manual

IT GB FR
Istruzioni
per l’utente
Installazione
Tutte le operazioni rela-
tive all’installazione (al-
lacciamento elettrico, al-
lacciamento gas, adat-
tamento al tipo di gas,
conseguenti regolazioni,
ecc.) devono essere ese-
guite da personale quali-
ficato secondo le norme
vigenti. Per le istruzioni
specifiche vedi la parte
riservata all’installatore.
Uso
Bruciatori gas (Figg. 1-3).
L'accensione del bruciatore
avviene avvicinando una
fiammella ai fori della parte
superiore dello stesso
premendo e ruotando in
senso antiorario la ma-
nopola corrispondente sino
a farne coincidere l'indice
con la posizione di mas-
simo. Ad accensione av-
venuta regolare la fiamma
secondo la necessità. La
posizione di minimo si
trova al termine delle rota-
zione antioraria. Nei
modelli con accensione
automatica agire sulla ma-
nopola come sopra
descritto, premendo con-
temporaneamente l'ap-
posito pulsante. Nei modelli
con accensione automatica/
simultanea (a una mano) è
sufficiente agire come sopra
descritto sulla sola
manopola corrispondente.
La scarica elettrica fra
candelina e bruciatore dà
luogo all'accensione del
bruciatore interessato. Ad
accensione avvenuta rila-
sciare immediatamente il
pulsante regolando la fiam-
ma secondo necessità.
L’accensione del bruciatore
nei modelli con sicurezza
termoelettrica avviene come
Instructions
for use
Installation
All the operations con-
cerned with the installation
(electrical and gas
connections, adaptation to
type of gas, necessary
adjustments, etc.) must be
carried out by qualified
technicians, in terms with
the standards in force.
For specific instructions,
kindly read the part re-
served for the installation
technician.
Use
Gas burners (Fig. 1-3).
The ignition of the gas
burner is carried out by
putting a small flame to the
upper part holes of the
burner, pressing and
rotating the corresponding
knob in an anti-clockwise
manner, until the maxi-
mum position has coincided
with the marker. When the
gas burner has been turned
on, adjust the flame
according to need. The
minimum position is found
at the end of the anti-
clockwise rotation
direction.
In models with automatic
ignition, operate the knob
as described above, pressing
simultaneously, the cor-
responding push-button.
For models with automatic/
simultaneous (with one
hand) ignition, it is
sufficient to proceed as
described above using the
corresponding knob. The
electric spark between the
ignition plug and the
burner provides the
ignition of the burner itself.
After ignition, immediately
release the push-button and
adjust the flame according
to need.
For models with a
thermoelectric safety
Notice
d’emploi
Installation
Toutes les opérations rela-
tives à l’installation
(branchement électrique,
raccordement gaz,
adaptation au type de gaz,
réglages nécessaires, etc...)
doivent être effectuées par
des spécialistes suivant les
normes en vigueur.
Pour les instructions spéci-
fiques, voir la partie qui
concerne les modalités
d’installation.
Mode d’emploi
Brûleurs à gaz (Fig. 1-3). On
allume le brûleur en ap-
prochant une petite flamme
aux trous de sa partie
supérieure en poussant et
tournant dans le sens
contraire des aiguilles d’une
montre la manette corre-
spondant jusqu’à faire coïn-
cider l’aiguille avec la
position de maximum.
Quand le bruleur est en
marche, règler la flamme
selon la nécéssité. La po-
sition de minimum se
trouve à la fin de la rotation
contraire au sens des aiguil-
les d’une montre.
Pour les modèles à allu-
mage automatique tourner
la manette comme indiquè
ci-dessus, en poussant en
meme temps le bouton
spècial. Pour les modèles à
allumage automatique/
simultané (à une main), il
suffit d’agir sur le bouton
correspondant, comme il est
indiqué ci-dessus. La dé-
charge électrique entre la
petite bougie et le brûleur
allume le brûleur interessé.
Quand le brûleur est
allumé, lâcher la manette, et
regler la flamme selon
nécéssité.
Dans le cas de modèles
doués de sûreté thermo-
4