Aruba Instant On AP17 Access Point Installation Guide The Aruba Instant On AP17 access points support IEEE 802.11ac standards for high-performance WLAN, and are equipped with two radios, which provide network access and monitor the network simultaneously. Multiple-in, Multiple-out (MIMO) technology allows these access points to deliver high-performance 802.11n 2.4 GHz and 802.11ac 5 GHz functionality, while also supporting 802.11a/b/g wireless services.
LED The AP17 access point is equipped with a LED that indicates the system status of the device. .
Before You Begin Refer to the sections below before beginning the installation process. The AP17 access point is designed in compliance with governmental requirements so that only authorized network administrators can change the settings. Identifying Specific Installation Locations Each location should be as close as possible to the center of the intended coverage area and should be free from obstructions or obvious sources of interference.
Figure 3 Attaching the Mount Bracket to a Wall 6. Slide the holder of the AP into the opening of the mount bracket and use the M6x45 screw included in the package to fix the AP to the mount bracket.
Figure 5 Attaching the AP to the Mount Bracket (Completed) Grounding the AP The grounding must be completed before powering up the access point. The grounding wire should be #8 AWG. 1. Peel the cover of one end of the grounding wire and place the bare grounding wire into the included copper lug, and press firmly with the crimping pliers. 2. Fasten the copper lug to the grounding hole on the AP with the included M4 x6 screw.
Figure 6 Cable Gland Exploded View Seals Sealing Nut Gland Body CAT 5E or Better Cable ! Failure to use the included Ethernet cable gland can lead to connectivity and POE issues. ! Outdoor rated Cat5e or above cable should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE. ! Cable feed must be pointed downwards when wall-mounted. The seals inside the clamping ring by factory default is applicable for cables with 5-8.5 mm diameter.
Figure 7 Instant On Portal Login Screen Electrical and Environmental Specifications Electrical Ethernet: One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45) Power: Maximum (worst-case) power consumption: 12.95W (802.3af PoE) Power over Ethernet (PoE): 802.3af complaint source Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.
! Toute modification effectuée sur cet équipement sans l'autorisation expresse de la partie responsable de la conformité est susceptible d'annuler son droit d'utilisation. Federal Communication Commission This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Luxembourg (LU), Malta (MT), Netherlands (NL), Norway (NO), Poland (PL), Portugal (PT), Romania (RO), Slovakia (SK), Slovenia (SL), Spain (ES), Sweden (SE), Switzerland (CH), Turkey (TR), United Kingdom (UK). Frequency Range MHz Max EIRP 2402-2480 9 dBm 2412-2472 20 dBm 5150-5250 23 dBm 5250-5350 23 dBm 5470-5725 30 dBm 5725-5850 14 dBm Medical 1. Equipment not suitable for use in the presence of flammable mixtures. 2.
Japan México La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada. Morocco Нормативные требования Евразийского Экономического Союза Russia HPE Russia: ООО "Хьюлетт Паккард Энтерпрайз" Российская Федерация, 125171, г. Москва, Ленинградское шоссе, 16А, стр.
Ukraine Hereby, Hewlett Packard Enterprise Company declares that the radio equipment type APIN0303 is in compliance with Ukrainian Technical Regulation on Radio Equipment, approved by resolution of the CABINET OF MINISTERS OF UKRAINE dated May 24, 2017, No. 355. The full text of the UA declaration of conformity is available at the following internet address: https://certificates.ext.hpe.com/public/certificates.html Hong Kong HK0011701620 Philippines Type-Approval No.
Contact Aruba Main Site https://www.ArubaInstantOn.com Support Site https://support.ArubaInstantOn.com Aruba Instant On Community https://community.ArubaInstantOn.com North America Telephone 1-800-943-4526 1-408-754-1200 International Telephone https://support.ArubaInstantOn.