2930M Switch Series

QuickSpecs
Aruba 2930M Switch Series
Technical Specifications
Page
22
10 Gbps Latency
< 3.4µs (FIFO 64-byte packets)
Throughput
112 Mpps
Stacking Performance
100 Gbps
Switching Capacity
320 Gbps
Switching Capacity
(including Stacking)
420 Gbps
Routing table Size
2,000 IPv4, 1,000 IPv6 in hardware, 200 OSPF, 256 Static, 10,000 RIP
Mac Address Table Size
32768 entries
Environment
Operating temperature
32°F to 113°F (0°C to 45°C) up to 5000ft, 32°F to 122°F (0°C to 45°C).
Derate -1 degree C for every 1000 ft from 5000 ft to 10000 ft
Operating relative
humidity
15% to 95%
(Non-condensing) 10,000 ft
Nonoperating/Storage
temperature
-40°C to +70°C
up to 15000 ft
Nonoperating/Storage
relative humidity
90% at 65C
(non-condensing); 15,000 ft
Acoustic
Sound Power LWaD=4.8 Bel, Sound Pressure LpAm, Bystander = 31.2 dB
Primary Airflow
direction
Port to Power
Electrical Characteristics
Frequency
50/60Hz
Maximum Heat
Dissipation
150 BTU/hr
162 kJ/hr
Voltage
JL086A PSU:
100-127/200-240 VAC
JL087A PSU:
110-127/200-240 VAC
Current
JL086A PSU (each): 5.9A/3A
JL087A PSU (each): 10A/5.1A
Maximum power rating
JL086A PSU (each): 554W
JL087A PSU (each): 957W
Idle Power
95W
PoE Power
(Max Possible)
860 Watts
Hibernate Power
7W
Notes
Idle power is the actual power consumption of the device with no ports
connected. Maximum power rating and maximum heat dissipation are the
worst case theoretical maximum numbers provide for planning the
infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports
plugged in, and all modules populated.
The operating temperature range for an Aruba 2930M switch is 0°C to 50°C (32°F to 122°F) if any of the following transceivers
are installed in the switch:
HPE X132 10G SFP+ LC SR Transceiver
J9150A
HPE X132 10G SFP+ LC LR Transceiver
J9151A
HPE X132 10G SFP+ LC LRM Transceiver
J9152A
HPE X132 10G SFP+ LC ER Transceiver
J9153A