303H Series Unified Hospitality Access Points

QuickSpecs
Aruba 303H Series Unified Hospitality Access Points
Overview
Page
4
•
802.11n/ac packet aggregation: A-MPDU, A-MSDU
WIFI
Antennas
• Two integrated dual-band moderately directional antennas for 2x2 MIMO with maximum individual antenna gain of
4.2dBi in 2.4GHz and 5.6dBi in 5GHz. Built-in antennas are optimized for vertical orientation of the AP.
• The horizontal beamwidth is roughly 120 degrees.
Combining the patterns of each of the antennas of the MIMO radios, the peak gain of the effective per-antenna pattern is
3.4dBi in 2.4GHz and 4.5dBi in 5GHz.
Other Interfaces
• Uplink: 10/100/1000BASE-T Ethernet (RJ-45, back)
- Auto-sensing link speed and MDI/MDX
- 802.3az Energy Efficient Ethernet (EEE)
- PoE-PD (input): 48 Vdc (nominal) 802.3af/at PoE
• Local: Three 10/100/1000BASE-T Ethernet (RJ-45, bottom)
- Auto-sensing link speed and MDI/MDX
- 802.3az Energy Efficient Ethernet (EEE)
- One port: PoE-PSE (output): 48 Vdc (nominal) 802.3af PoE
• Passive pass-through interface (two RJ-45, back and bottom)
- Bluetooth Low Energy (BLE) radio
 Up to 4dBm transmit power (class 2) and -93dBm receive sensitivity
 Integrated antenna with moderately directional pattern and peak gain of 0.9dBi
• USB 2.0 host interface (Type A connector)
- 3G/4G cellular modems
- Device battery charging port
- Capable of supplying up to 1A/5 watts of power to an attached device
• DC power interface, accepts 1.35/3.5-mm center-positive circular plug with 9.5-mm length
• Visual indicators (LEDs):
- Power/system status
- Radio status
- PoE-PSE status
- Local network port status (3x)
• Reset/LED control button (“paperclip access”)
- Factory reset (when activated during device power up)
- LED control: toggle off/normal
- Serial console interface (custom, uUSB physical jack)
Encrypted Throughput
• Maximum IPsec encrypted wired throughput: 100Mbps
Power Sources and Consumption
• The AP supports direct DC power and Power over Ethernet (PoE)
• When both power sources are available, DC power takes priority over PoE
• Power sources are sold separately
• Direct DC power source: 48Vdc nominal, +/- 5%
• Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af/802.3at compliant source
- Unrestricted functionality with direct DC power. When using an 802.3af PoE source, the PoE out (PSE) capability
of the 303H is always disabled.