LCM0802TV Owner’s Manual Audiovox Specialized Applications, LLC 23319 Cooper Dr. Elkhart, IN 46514 1-800-688-3135 www.asaelectronics.
Important Notice Television Reception It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver’s seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, the LCM0802TV should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle.
FEATURES Congratulations on your purchase of the Flexvision LCM0802TV drop down TV/Video monitor. The LCM0802TV has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product and to ensure that you obtain the best results from your equipment.
FRONT PANEL FEATURE Figure 1 2 3 4 1 5 6 7 8 9 10 -4-
FRONT PANEL FEATURES – See Figure 1 1. Sensor Eye – Allows the remote control to operate the LCM0802TV’s OSD system (On Screen Display), volume to wired headphone jacks (and optional external speakers), and for control of Video Cassette Player and other accessories. 6. Channel Up/Down – Changes the TV channel. 2. Power Button – (Bright red when system is ON, dim when system is OFF). 8. Dome Lights – Provide additional illumination. 7.
REMOTE CONTROL OPERATION 1 6 3 2 BATTERY INSTALLATION Before attempting to operate your Remote Control, install the batteries as described below. 1) Turn the remote control face down. Press down on the ridged area of the battery cover, and slide it off. 2) Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed. 3) Slide the cover back until it clicks into position.
Remote Controlled TV Functions 1. POWER ON/OFF Press this button to turn the LCM0802TV on. The channel number or current video source will be displayed on screen, and the picture will appear in a few seconds. Press the button again to turn the LCM0802TV off. 2. DIRECT ACCESS (0-9) BUTTONS Use these buttons to make a direct channel selection. The channel number chosen will be displayed on the screen for about 4 seconds. The direct access is carried out with 0-9 keys (0-99CH).
. AUTO MEMORY BUTTON When the AUTO MEMORY BUTTON is depressed, all channels in TV mode are searched and tuned; all channels with video signals detected are automatically stored. Please refer to page 2 for more information on TV reception. 9. SKIP/SEARCH BUTTON This button selects between SKIP and SEARCH mode. In “SKIP mode” the TV only stops on channels that are programmed into memory when the CHANNEL UP/DOWN buttons are used. When the SKIP is turned off, the TV will only stop on all active channels. 10.
CHANNEL TUNING SETUP In order to easily access all available channels, it may be necessary to perform channel auto-programming whenever the vehicle’s geographic location has changed, i.e. city to city, weak signal area. 1. Press the AUTO MEMORY button on the remote control unit or the AUTO PROGRAM button on the flip down video unit. You will see the TV cycle through all it’s channels. The built-in microprocessor will automatically note each channel that is actively broadcasting in your area. 2.
OPERATION Remote Sensor Overhead Dome Lights This lights integrated into the LCM0802TV are controlled by a three position slide switch. Sliding the switch to the on position will turn the lights on. The off position will prevent the lights from turning on at all times and the auto position will allow the lights to turn on and off with the vehicle’s interior lighting. Do not leave the vehicle unattended with the dome light switch in the on position, as this could result in a discharged battery.
OPTIONAL ACCESSORIES Auxiliary A/V Stereo Inputs Jack Wireless Headphones The LCM0802TV may be equipped with an auxiliary A/V stereo input connector (optional). These inputs are provided to facilitate the temporary connection of optional audio/video equipment, such as a camcorder or video game system. To play a source with these inputs, an RCA patch cord is required to connect the audio/video signals to their respective jacks.
Video Output The LCM0802TV provides a video output for an optional video monitor(s). This output will provide a video signal that duplicates the signal displayed by the LCM0802TV to an additional monitor or video display. Please see your installer for more information. Flexvision Video Cassette Player (Aux Video 1) In most installations a VCP will be connected to the “Video 1” input.
TYPICAL SYSTEM CONNECTIONS TO FM TRANSMITTER 15 16 49 MHz FM Transmitter 17 13 SPEAKER OR HEADPHONE CONNECTION 14 LINE OUT-L LINE OUT-V LINE OUT-R 9 8 7 12 10 6 TWO DOME LIGHT’S CONNECTION 5 4 3 Negative Dome Light Switching POWER(+ 12V) POWER(GND) White - Entry Switch/Negative Black - Constant + 12VDC/Dome Red- Chassis Ground 2 1 Positive Dome Light Switching White - Entry Switch/Positive Black - Chassis Ground Red- Constant + 12VDC/Dome 18 11 PIN 1 – Power/Red PIN 2 – Power G
ACCESSORY LIST DESCRIPTION AVP-7285 Video Cassette Player (12 Volt) FM Modulator Wireless Headphone Kit: Includes 2 sets Wireless Headphones and transmitter AVP-7000 Video Cassette Player (12 Volt) Mini-Console (Trim Ring) AC2A 2 Amp Adapter for use with Avt-597 5” TV and AVP-7000 Video Cassette Player Unified Remote Control VAC-21 12 Volt Corded Vacuum AVF-1 12 Volt Rechargeable Flashlight HP-175 Headphones with Pivoting Ear Cup HP-275 Headphones with Volume Control on Cord HP-375 Studio Quality Headphone
Troubleshooting PROBLEM Poor TV Reception SOLUTION • • • Poor radio reception (FM modulator installed) • • • IR sensor inoperative Specifications • • • Perform auto programming of the tuner Verify antenna condition. NOTE: Due to the nature of TV signals, vehicle motion, direction the vehicle is facing, distance from the transmitter, nearby surroundings and weather may adversely affect TV reception.
The Mobile Electronics Company 90 DAY/ 12 MONTH LIMITED WARRANTY AUDIOVOX SPECIALIZED APPLICATION, LLC (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced (at the Company's option) without charge for parts and repair labor.
UDIOVOX PECIALIZED PPLICATIONS, L.L.C. 23319 Cooper Dr. Elkhart, IN 46514 800-688-3135 www.asaelectronics.