LCM1042TV Owner’s Manual CHANNEL AP TV/AV VOLUME PIC. SEL. Audiovox Specialized Applications, LLC 23319 Cooper Dr. Elkhart, IN 46514 1-800-688-3135 www.asaelectronics.
Important Notice Television Reception It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver’s seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, the LCM1042TV should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle.
FEATURES Congratulations on your purchase of the Flexvision LCM1042TV drop down TV/Video monitor. The LCM1042TV has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product and to ensure that you obtain the best results from your equipment.
FRONT PANEL FEATURE Figure 1
FRONT PANEL FEATURES – See Figure 1 1. Power Button – (Bright red when system is ON, dim when system is OFF). 2. Channel Up/Down – Changes the TV channel. 3. Auto Program – Press this button, the TV will automatically scan and memorize the strong signal channels. 4. Sensor Eye – Allows the remote control to operate the LCM1042TV’s OSD system (On Screen Display), volume to wired headphone jacks (and optional external speakers), and for control of Video Cassette Player, DVD Player and other accessories. 5.
REMOTE CONTROL OPERATION 5 TV POWER TV/VIDEO MUTE 6 1 1 2 3 CH 4 5 6 CH 7 8 9 0 1-- BATTERY INSTALLATION 3 Before attempting to operate your Remote Control, install the batteries as described below. 1) Turn the remote control face down. Press down on the ridged area of the battery cover, and slide it off. 2) Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed. 3) Slide the cover back until it clicks into position.
Remote Controlled TV Functions 1. POWER ON/OFF Press this button to turn the LCM1042TV on. The channel number or current video source will be displayed on screen, and the picture will appear in a few seconds. Press the button again to turn the LCM1042TV off. 5. TV / VIDEO BUTTON Any video equipment connected to the AUDIO/ VIDEO inputs can be used with the TV by pressing this button. Each time the button is pressed, the Audio/Video source will change in the following sequence VIDEO 1, VIDEO 2 and TV. 2.
When skip mode is on, the LCM1042TV will tune to only the stored channels when using the CHANNEL UP/DOWN buttons. 9. AUTO MEMORY BUTTON Press this button, the TV will automatically scan and memorize the strong signal channels 12. PLAY BUTTON Press this button to activate play mode while a tape I is loaded into the VCP. This button may also be used to disengage search and pause modes. For more information, consult the VCP owner’s manual.
CHANNEL TUNING SETUP 3. To ERASE a channel, press the ERASE/ WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE ” is displayed on screen. To STORE a channel, press the button until the MANUAL MEMORY XX ADD is displayed on screen. Note: Please refer to page 2 for more information on TV reception. In order to easily access all available channels, it may be necessary to perform channel auto - programming whenever the vehicle’s geographic location has changed, i.e.
OPERATION Overhead Dome Lights This lights integrated into the LCM1042TV are controlled by a three position slide switch. Sliding the switch to the on position will turn the lights on. The off position will prevent the lights from turning on at all times and the auto position will allow the lights to turn on and off with the vehicle’s interior lighting. Do not leave the vehicle unattended with the dome light switch in the on position, as this could result in a discharged battery.
OPTIONAL ACCESSORIES Auxiliary A/V Stereo Inputs Jack Wireless Headphones The LCM1042TV includes a RF transmitter (P/N WUX or WUX3) for use with optional Flexvision wireless headphones. Tuning the headphone switch on, and wearing them activates the internal micro switch, (which includes a tuning knob to tune into the preset frequency on the RF transmitter), which will activate the internal RF receiver and the volume can be adjusted separately with the controls on the headset.
Video Output Flexvision Video Cassette Player (Aux Video 1) The LCM1042TV provides a video output for an optional video monitor(s). This output will provide a video signal that duplicates the signal displayed by the LCM1042TV to an additional monitor or video display. Please see your installer for more information. In most installations a VCP will be connected to the “Video 1” input.
TWO DOME LIGHT’S CONNECTION 3 4 5 7 8 9 LINE OUT- L Negative Dome Light Switching DIN 1 DIN 2 14 Antenna SPEAKER OR HEADPHONE CONNECTION 12 LINE OUT- R 10 LINE OUT-V 6 13 15 18 17 16 TO FM TRANSM ITTER 49 Mhz FM Transmitter 11 POWER(+ 12V) 1 2 POWER(GND) TYPICAL SYSTEM CONNECTIONS White - Entry Switch/Negative Black - Constant + 12VDC/Dome Red- Chassis Ground Positive Dome Light Switching Accessory Harness White - Entry Switch/Positive Black - Chassis Ground Red- Constan
OPTIONAL PRODUCT LIST Televisions AVT-988 9” CRT Color Television with Remote (12V) AVT-1498 13” CRT Color Television with Remote (12V) VCP and DVD Players for use with CRT and LCD products AVP7000 Video Cassette Player (12V) AVP7285 Stereo Video Cassette Player (12V) Single Disc DVD player (DIN) Headphones Wireless Headphones Wired Headphones with Pivoting Ear Cup Wired Headphones with Volume Control on Cord Studio Quality Headphones Miscellaneous Remote Controls Wallmount Family Radio Service with 4 Hand
Marine AM/FM Stereo with CD Player AM/FM/Weatherband Stereo with Cassette Player AM/FM Stereo with Cassette Player (analog tune) AM/FM Stereo with Cassette Player (analog tune) Weatherproof Radio Housing 50 Watt 6-1/2” Speakers (white/black) 30 Watt 5” Speakers (white/black) 30 Watt 4” Speakers Marine Radio Antenna MS1000 MS407 MS306 MS220 MRH211 AMS6 AMS5 AMS4 AN125 Unlike household electronics, all of our products have been specifically designed and tested for the mobile environment and are only availab
Troubleshooting PROBLEM Poor TV Reception SOLUTION • • • Poor radio reception (FM modulator installed) • • • Perform auto programming of the tuner Verify antenna condition. NOTE: Due to the nature of TV signals, vehicle motion, direction the vehicle is facing, distance from the transmitter, nearby surroundings and weather may adversely affect TV reception. These conditions may result in the following: picture roll, “snowy” picture, or momentary loss of color.
The Mobile Electronics Company 90 DAY/ 12 MONTH LIMITED WARRANTY AUDIOVOX SPECIALIZED APPLICATION, LLC (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced (at the Company's option) without charge for parts and repair labor.
UDIOVOX PECIALIZED PPLICATIONS, L.L.C. 23319 Cooper Dr. Elkhart, IN 46514 800-688-3135 www.asaelectronics.
