User's Manual

User Manual
Handsfree-System
The document hereon is the property of Asahi Denso Co., Ltd.
Page 5 of 17
ZKM013-820_0
Motorcycle start (Turn on the ignition and start the engine)
Smart key
User recognition with the Smart key (2) is performed as described below:
A. Press the knob on the Ignition SW (1).
B. The Control unit (4) installed on the Ignition SW (1) requires the Smart key (2) for a radio frequency
identification with an LF signal transmitted by the LF antenna incorporated in the Control unit (4).
C. If the Smart key (2) is within a range of 1.0 m from the vehicle and the battery is adequately charged, replies
to the Control unit (4) and starts authentication.
D. After successful authentication, Ignition switch knob becomes rotatable for 5 seconds. While the knob is
rotatable, LED (6) is lit. When the knob is rotated to the ON position, the main power of the vehicle turns
ON and engine can be started. If authentication failed, engine can’t be started.
E. Press the starter switch on the handle switch to start the engine.
Immobilizer key
User recognition with the Immobilizer key (3) is performed as described below:
A. Press the knob on the Ignition SW (1).
B. After about 3 seconds, the Control unit (4) installed on the Ignition SW (1) requires the Immobilizer key (3)
for a low frequency identification with an LF signal transmitted by the LF antenna incorporated in the
Control unit (4).
C. If the Immobilizer key (3) is near the LF Antenna in the Control unit (4), replies to the Control unit (4) and
starts authentication.
D. After successful authentication, Ignition switch knob becomes rotatable for 5 seconds. While the knob is
rotatable, LED (6) is lit. When the knob is rotated to the ON position, the main power of the vehicle turns
ON and engine can be started. If authentication failed, engine can’t be started.
E. Press the starter switch on the handle switch to start the engine.
Immobilizer set position