User's Manual Hub/Switch FH208B/FH208/FH216B/FH216

Cabling and Voltage Requirements
Page 2-5
Voltage Requirements
Voltage requirements for all models:
❑ 100 to 240Vac, 50/60Hz, 1.2A maximum
▲ Important! Check the AC power line voltage used in your
area.
Placement and Mounting
Hub Location
The location chosen for the Dual-speed FriendlyNet Hub should be less than
100 meters from servers, workstations, or switches.
▲ Caution! Category 5 cables are environment-sensitive.
Make sure that the cable route is not too close to electro-
magnetic noise sources such as power lines or fluorescent
lights.
Self-adhering Rubber Feet
To place the hub on a the desktop, apply the self-adhering rubber feet to the
bottom four corners as shown in Figure 2-8.
Figure 2-8 Self-adhering Rubber Feet
Desk Stands
Desk stands easily attach to a hub without screws, bolts or tools. See Figure 2-9.
To stack hubs using desk stands:
1 Attach two stands to each side of the first hub.
FriendlyNet FH216
Link/Act
100Mbps
MDI – II
MDI – II
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
13 14 15 16
5678
9 10 11 12
1234
16-port Dual-speed Ethernet Hub
Auto
Power Switch
Collision
10 100
or
or
10/100Mbps Ports
10/100Mbps Ports