Specifications

B - 6 WFPEEUI220001C0
ECCP Software Installation
ECCP Software Installation
If the system contains an ECCP network interface board for
connection to the Cnet, the ECCP Windows driver and utility
interface software must be installed. If the system does not
contain an ECCP board, skip this section and proceed to Gen-
Gen-Gen-
Gen-
eral Network Interface Software Installation
eral Network Interface Software Installationeral Network Interface Software Installation
eral Network Interface Software Installation. If the system
contains both an ECCP board and a single Ethernet board, the
software related to the ECCP board should be installed first.
If the ECCP software is being installed for the first time, refer to
Initial ECCP Software Installation
Initial ECCP Software InstallationInitial ECCP Software Installation
Initial ECCP Software Installation.
If the ECCP software has already been installed on the system,
refer to Re-Installing/Upgrading the ECCP Software
Re-Installing/Upgrading the ECCP SoftwareRe-Installing/Upgrading the ECCP Software
Re-Installing/Upgrading the ECCP Software (Win-
(Win- (Win-
(Win-
dows NT)
dows NT)dows NT)
dows NT).
When rebooting a Windows 2000 workstation after installing
the ECCP board, choose to install the proper driver when
prompted to do so by the found new hardware wizard dialog
box.
Initial ECCP Software Installation (Windows NT)
If the ECCP software has not previously been installed on the
system, perform the following steps to install it on Windows NT
4.0.
1. Load the CD-ROM disk containing the Conductor NT soft-
ware into the CD-ROM drive.
2. Select Start > Settings > Control Panel.
3. In the control panel window, double click Network. The net-
work window will be displayed.
4. Select the Adapters tab, then click Add. The select network
adapter window will be displayed.
5. Click Have Disk.
6. Insert the manufacturer’s disk and enter the CD-ROM
drive specification, followed by the directory i386\ECCP\NT4
i386\ECCP\NT4i386\ECCP\NT4
i386\ECCP\NT4.
For example, if the CD-ROM is drive D:, enter:
D:\i386\ECCP\NT4