User manual

Page 4-4
Troubleshooting
Using the Diagnostic Program
The diagnostic program runs diagnostic tests to help you identify problems
on the adapter and provides configuration information on your adapter.
PC Diagnostic Program
To run the diagnostic program on your PC, follow the procedure below.
1
Insert the Asanté Driver Disk into drive A.
2
At the DOS prompt, type the following command:
A:\UTILITY\DIAGPCI
3
Press Enter.
A window appears displaying a warning message that you should
read.
4
Press C to continue (or ESC to abort the diagnostic program).
The diagnostic program searches for adapters installed in your
computer system. A screen appears showing you the adapters
found.
5
Select the appropriate adapter from the list and press Enter.
Use the UP or DOWN arrow key to make a selection.
A Screen appears showing you the following menu options:
❏ Loopback Tests: Tests the adapter by sending packets
across the components for loopback tests.
❏ Adapter Status: Displays the adapter configuration infor-
mation such as PCI slot number, base I/O address, inter-
rupt line, media type, network speed, and Ethernet node
address.
❏ Go Back to previous screen
6
Select Loopback Tests and press Enter.
The program runs a series of tests. Their results are displayed for
you after each test with a PASSED or FAILED indication.
7
When the tests finish, verify the results to make sure that all tests
passed.