Setup guide

15
IntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit
When attaching a workstation to the switch, a standard straight-through CAT5 cable may be used.
3.9 Connecting to the Console Port
The DB-9 serial port located on the front panel is used to connect to the switch for out-of-band console configuration.
The on-board configuration program can be accessed from a terminal or a PC running a terminal emulation program.
The pin assignments used to connect to the serial port are provided in the following tables.
3.9.1 Wiring Map for Serial Cable
The following table describes the serial cable wiring information.
Switch’s 9-Pin Serial Port Null Modem PC’s 9-Pin DTE Port
2 RXD (receive data) ! 3 TXD (transmit data)
3 TXD " 2 RXD (receive data)
5 SGND (signal ground) --- 5 SGND (signal ground)
The serial port configuration requirements are as follows:
• Default Baud rate—9,600 bps
• Character Size—8 Characters
• Parity—None
• Stop bit—One
• Data bits—8