User`s manual

User’s Manual 85
Chapter 7: Configuring Ports
7.1 Displaying Connection Status
You can use the Port Information or Trunk Information pages to display the current connection status,
including link state, speed/duplex mode, flow control, and auto-negotiation.
Field Attributes (Web)
Name – Interface label.
Type – Indicates the port type.
(1000BASE-T, 1000BASE-SX, 1000BASE-LX or 100BASE-LH)
Admin Status – Shows if the interface is enabled or disabled.
Oper Status – Indicates if the link is Up or Down.
Speed Duplex Status – Shows the current speed and duplex mode. (Auto, or fixed choice)
Flow Control Status – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or None)
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
Forced Mode1 – Shows the forced/preferred port type to use for combination ports 21-24 or 45-48. (Copper-
Forced, Copper-Preferred-Auto, SFP-Forced, SFP-Preferred-Auto)
Trunk Member1 – Shows if port is a trunk member.
Creation2 – Shows if a trunk is manually configured or dynamically set via LACP.
1: Port Information only.
2: Trunk Information only
Configuring Switch Using the Web or CLI
Web
Click Port – Port Information or Trunk Information.