Installation guide

Page 4
Installing the RJ45B Module
Installing a Recessed
Mini MAU
If you plan to use an Asanté recessed Mini MAU, you need to connect
it to the recessed AUI connector before you install the module.
To install a recessed Asanté Mini MAU:
1
Unscrew the two ejector screws on each side of the
module’s front panel and pull out the module approx-
imately four to five inches from the chassis. See
Figure 2.
Figure 2 The Mini MAU filler plate in the RJ45B Module
2
Remove the Mini MAU’s filler plate.
3
Insert the Mini MAU by guiding it into the recessed
slot until it is securely fastened to its connector.
4
Reinsert the module into the chassis.
ASANTÉ
NetStacker-RJ45