User's Manual

6 of 12
Power On/Off
Baby Unit
• When the unit is off, press and hold to turn on the unit.
• All LEDs will turn on for about 2 seconds and then turn off, except
the LED for the nightlight button.
• The LCD will turn on. LED for the nightlight button will turn on.
• LINK LED starts to blink while unit searches for the parent unit &
becomes steadily lit when successfully links to the parent unit.
• To power off the unit again, press and hold . The power off tone
is heard. The LCD and all LEDs will turn off.
Parent Unit
• When the unit is off, press and hold to turn on the unit.
• All LEDs will turn on for about 2 seconds.
• The LCD will turn on.
• LINK LED starts to blink while unit searches for the baby unit &
becomes lit when successfully links to the baby unit.
• To power off the units again, press and hold . The power off
tone is heard. The LCD on the Parent Unit will turn off.
Note: The parent unit can be used on or off the charging cradle. When
on cradle, the batteries will be recharged at the same time.
However, the time it takes to charge the batteries to full will be
longer when the unit is charged and used at the same time.
When off cradle, the batteries will lose charge over the time, even
if the parent unit is turned off.
Monitoring
• Position the baby unit accordingly. It should be placed at least 1
meter away from the baby.
• Take the parent unit to monitor.
• Audio picked up by the baby unit microphone is depicted on the 8
LEDs on the parent unit (5 green and 3 red). The more audio is
picked up, the more LEDs will be lit. When no audio is picked up,
all 8 LEDs will be off.
• If the volume of the Parent Unit is turned off, an alert will be sound
when the audio picked up reach the second red led.
Note: Do not position the baby unit and the parent unit close to each
other as a high-pitched feedback noise may be generated.
Sensitivity
You can adjust the sensitivity of the Baby Unit’s microphone from the
Parent Unit. For example, if your baby is a particularly quiet sleeper,
you can increase the sensitivity levels so that you are sure to hear if
baby disturbs or becomes uncomfortable.
• Press . Use or button to scroll until Sensitivity is
displayed.
• Press .
• Use or button to select the sensitivity level. The display
shows the current sensitivity level. For example, Level .
• There are five levels of sensitivity, , , , , .
represents the highest sensitivity. represents the lowest
sensitivity.
• Press to confirm. The display reads Saved and then returns
to Sensitivity menu.
• Press to exit.
Adjusting Volume
There are 5 volume levels on each Unit and there is also an Off setting
on the Parent Unit.
On the units,
• Press the volume up button ( for Baby Unit, for Parent
Unit) to increase the volume or the volume down button( for
Baby Unit, for Parent Unit) to decrease the volume
Note: You cannot switch the volume off on the Baby Unit.