User's Manual

The System
- 47 -
RESTORING DEFAULT SETTINGS
You can reset your phone settings to the original factory settings.
1. Press .
2. Select A
AA
Advanced set
dvanced setdvanced set
dvanced set 

 Reset
Reset Reset
Reset. Press OK . The handset displays a
confirmation request.
3. Press OK to confirm. All settings have been reset.
To see a list of default setting, see Default (pre-programmed) settings on page 56.
NOTE:
A
fter reset, your handset’s power switches off. It will switch back
on in a few seconds after updating all the settings. All handsets return
to the Welcome screen after reset.
- 48 -
The Answering Machine
Once switched on, your answering machine is ready to be used. By default, your
answering machine is set to Answer and Record mode. You can also access the
machine remotely.
7-SEGMENT DISPLAY
Your answering machine comes with a 7-segment display to show you the
number of messages you have and other visual messages about its operation.
--
Memory full
00
AA
Remote access
Recording
The 2-digit number shows:
- The volume level, or
- The message number
(blink for new messages)
SWITCHING THE ANSWERING MACHINE ON/OFF
From the base
1. Press during standby.
From the handset
1. Press .
2. Select A
AA
Ans machine
ns machinens machine
ns machine 

 A
AA
Ans
nsns
nswer
werwer
wer on/off
on/off on/off
on/off. Press OK .
3. Select the new setting. Press OK . The setting is saved.
Once switched on, your answering machine will answer incoming calls after a
certain number of rings depending on the ring delay setting. See Setting the ring
delay on page 54.