User's Manual
13
Service Centre Quick Access
The Service Centre quick access allows you to call the service center (eg.
helpline, support centre of network provider) by a single key press. Refer to
the section of programming for how to enter or edit the service centre phone
number.
• Press and hold “0” in Standby to
seize the line.
• The programmed number will be
dialed.
(The number will be displayed on
LCD and the number can hold up
to 30 digits.)
• Call timer and talk time remaining
counter are displayed accordingly.
• Press PHONE key again to end
the call.
Things you can do during a call
You can do the following during a call,
a. Adjust speaker volume;
b. Mute call;
c. Change dial tone;
d. Send flash signal;
e. Dial extra digits;
f. Dial from phonebook record;
g. Display user phone number.
Adjust Speaker Volume
16 different levels of speaker volume can be selected.
• Press UP/DOWN key to adjust the
speaker volume during the call.
Mute Call
All the calls can be muted or unmuted.
• Press MUTE key to mute or un-
mute the call.
(When the call is muted, mute
icon turns on and LEDs on POD
turn RED and flash).
Note: If the service center number is not entered or is modified and
contains no digit, you will hear a reject tone and no call will be
dialed.
Note: If the service centre number has more than 18 digits, only the
last 18 digits shall be displayed. The Scroll icon shall turn on.