User's Manual

8
Basic Steps to Install
1. Place the base and POD units on a flat and stable surface.
2. Connect the output plug of the base adapter to the socket on the
bottom of the base unit and the adapter to the mains wall outlet. The
power LED on the base should become steadily lit.
3. Connect one end of the telephone line to the socket on the bottom
of the base unit and the other end to the wall phone socket.
4. Plug the battery pack (6xAA size), observing their polarities, into the
connector in the battery compartment on the POD.
5. Slide the battery door firmly into place.
6. Connect the output plug of the POD adapter to the socket on the
back of the POD unit and the adapter to the mains wall outlet. The
battery must be charged for at least 12 hours before first use.
CAUTION
Use only the AC adapters supplied with this telephone. Incorrect adapter
polarity or voltage can seriously damage the unit.
For Base: For POD:
Input: 120 VAC 60 Hz Input: 120 VAC 60 Hz
Output: 7 VDC 400 mA Output: 12 VDC 500 mA
Polarity: Center positive Polarity: Center positive
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. Refer to the original type supplied with this telephone. NiMH
rechargeable batteries must be disposed of in accordance with applicable
waste disposal regulations.
Charging the POD
If the battery icon flashes or a warning beep is emitted from the POD, the
battery pack needs recharging. Connect the POD to the AC adapter plugged
to the mains wall outlet to start charging.
To Ensure Better Performance
1. Locate the conference telephone in a quiet environment.
2. Seat all participants the same distance from POD
3. Speak toward the POD microphones at normal conversation levels.
4. Do not move the POD during a call.
BASIC OPERATIONS
During Standby
• When the phone is not in use, the
POWER LED on the base is
turned on and the LCD on the
POD displays your phone number,
if programmed.
Answering Calls
When there is an incoming call, the GREEN LEDs on the base and the POD
blink. icon flashes on the display. The speaker on the POD rings the
selected melody.
• Press any key to answer.
• The call timer and clock icon are
displayed. The call timer starts
with MM:SS.
• The talk time remaining counter
and hour glass icon are also
displayed.
7
Note:
1. The call timer displays the time elapsed on the current active call.
2. The talk time remaining counter displays the estimated remaining in use
time at the current battery level before the batteries become empty. If for
any reason the talk time remaining counter displays 00-00 for a prolonged
period of time or is severely inaccurate, charge the POD for a full 12
hours and the counter should reset.