User's Manual
Table Of Contents
- USA 8Q Owners Manual 0221-14 P01 NEW
- USA 8Q Owners Manual 0219-14 P02 KDA
- USA 8Q Owners Manual 0219-14 P03
- USA 8Q Owners Manual 0219-14 P04
- USA 8Q Owners Manual 0219-14 P05
- USA 8Q Owners Manual 0219-14 P06
- USA 8Q Owners Manual 0219-14 P07
- USA 8Q Owners Manual 0219-14 P08
- USA 8Q Owners Manual 0221-14 P09 NEW
- USA 8Q Owners Manual 0220-14 P10 NEW
- USA 8Q Owners Manual 0219-14 P11
- USA 8Q Owners Manual 0219-14 P12
- USA 8Q Owners Manual 0219-14 P13
- USA 8Q Owners Manual 0219-14 P14
- USA 8Q Owners Manual 0219-14 P15
- USA 8Q Owners Manual 0219-14 P16
- USA 8Q Owners Manual 0219-14 P17
- USA 8Q Owners Manual 0219-14 P18
- USA 8Q Owners Manual 0219-14 P19
- USA 8Q Owners Manual 0220-14 P20 NEW
- USA 8Q Owners Manual 0219-14 P21
- USA 8Q Owners Manual 0219-14 P22
- USA 8Q Owners Manual 0220-14 P23 NEW 2
- USA 8Q Owners Manual 0220-14 P24 NEW 2
- USA 8Q Owners Manual 0220-14 P25 NEW 2
10
Frame Assembly Instructions
Return the adjustable foundation to the flat position
and proceed to assemble the Mattress Retainer
Brackets.
STEP 8
Use the Retainer Bolts (F) and Retainer Bar Plate
(I) to fasten the Mattress Retainer Brackets (B) to
the front of the adjustable foundation. (As shown
in the diagram).
STEP 9
NOTE: Use only a manual screwdriver to
install the retainer bolts. DO NOT use a power
screwdriver to tighten the bolts. DO NOT over
tighten the mattress retainer hardware.
STEP 7
Install the batteries in your wireless remote control.
Briefly activate all functions on the wireless remote
control to verify that all of the features are operational.
If your Reverie 8Q Adjustable Foundation does
NOT
operate,
please refer to the Troubleshooting
section beginning on page 22 of this manual.
NOTE: It is important to position the bottom
of the headboard cross member a maximum
distance of 3 inches (76.2 mm) between the
headboard and the top of the mattress.
Do not exceed 3 inches (76.2 mm).
NOTE: If the adjustable foundation is to be
set up without a headboard, simply install a
mattress on the frame. Installation is now
complete. If a headboard is to be installed,
proceed to step 10.
STEP 10
Install the headboard brackets to the adjustable
foundation. Place one bracket on the left-hand
side of the adjustable foundation and one
bracket on the right-hand side of the adjustable
foundation.
CUSTOMER SERVICE: 800-973-8374
DO NOT
lean the adjustable
foundation against the
installed legs to flip it over.
ATTENTION !
Improper handling
Carefully rotate the
adjustable foundation
over to
the topside up position.
STEP 5
Plug the power cord into a grounded electrical
outlet.
STEP 6
NOTE: An Electrical surge protection unit is
recommended (not included).
ATTENTION: For any King / Split King
configuration, do not add center retainer bars
for either foundation on head or foot.
When two Twin XLs or two Split California Kings
are put together, DO NOT install retainer bars
in the center head or center foot secon
of the foundaons.
+
+