User's Manual

Table Of Contents
PRELIMINARY
TD 92417GB
2007-02-19/ Ver. PA
User Manual
Ascom a71 Alarm Tranceiver and Ascom p71 Transceiver
6
2.2.3 PCR Charging Rack
The wall mounted PCR Charging Rack (PCR) is used for charging the transceivers. The PCR
is a modular system that consists of a master module (PCR-M), extension modules (PCR-E)
and power supplies. Each PCR module has six charging slots.
Figure 6.
006
Figure 6. PCR with power supply, one PCR-M and two PCR-E
One PCR-M can support up to 20 PCR-E, which gives a charging possibility of 126
transceivers. A power supply feeds up to three Charging Rack modules (one PCR-M and
two PCR-E), which results in seven power supplies for the above example.
Transceivers with a pull-cord and/or a security string can be charged in the PCR Charging
Rack without removing the pull-cord.
For further information about the PCR refer to its Data Sheet, Portable Charging Rack,
TD
92355GB and Installation Manual, PCR Charging Rack, TD 92356GB.
Note: When charging an EX-version, the PCR Charging Rack must be marked with CR2.
2.3 Accessories
Belt Clip, Swivel Type
The ordinary belt clip can be replaced by a special swivel type, adapted to firmly place the
transceiver in the belt.
Leather Case
As accessory, there is a leather case especially designed for the transceiver used to increase
the protection of wear and tear. It is possible to use the transceiver while it is placed in the
case. The clip of the transceiver is not necessary to remove.
Name Label Kit
For the transceiver, a name label kit can be ordered. The name label is possible to use for
own means of identification.