Operation Manual

TD 92477EN
15 June 2012 / Ver. G
User Manual
Ascom d62 DECT Handset
16
The three Soft keys are located just beneath the display and the functions of each Soft key
is indicated by text in the display just above the keys.
In idle mode, the Soft keys can be used for specific functions defined by the user of the
handset.
3.4.8 Hot Keys
Any key "0", "2" - "9" can be set to a Hot Key. A long press on any of these numbers in stand
by mode are by default a short cut to the Call contact list. The list is in alphabetic order, and
depending on which key that is pressed is dependent on where in the list the contact
appears.
A Hot Key can be programmed to give access to frequently used functions such as dialling a
specific handset number, a short cut on the menu, or sending an SMS.
3.4.9 Multifunction Button
Note: This feature is applicable for d62 Talker and d62 Messenger only.
This button can be used as a short cut to functions; long or double press modes. It is by
default not used, but can be defined by the user of the handset. If the button is defined, it
can be used in standby mode only.
3.4.10 Volume Button
The two buttons placed on the upper left side of the handset are used for increasing/
decreasing the earpiece, headset, and the loudspeaker volume.
3.5 Alphanumeric Keys
Figure 5. Available characters.
NOTE: Depending on the selected menu language and character setting in the IMS3/Unite
CM, other characters can be available. This means that the character order can differ from
the figure above.
In standby mode, and number input mode
• A short press on a key enter the digits “0” - “9” and the characters * and #.
• Enter a pause in number input mode by a long press on the # -key. A pause is indicated
by a "P" in the display.
006
. , ? ! - ‘ ” 1
a b c à â ä æ ç 2
d e f é è 3
j k l 5
m n o ñ ò ö ø 6
t u v ù ü 8
#
g h i î 4
b
p q r s β 7
w x y z 9
Space + * 0