User's Manual

TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
119
4 On each mapping line, a Call Number Type can be selected from the Call Number
Type drop-down list (found on the righthand side of the lines).
NOTE: This step is optional.
Possible values are:
• Unknown: The mapping applies to unknown, external calls
• ISDN: The mapping applies to external calls
• Private: The mapping applies to internal calls
5 On each mapping line, a Call Number Format
can be selected from the Call Number
Format drop-down list (found on the lefthand side of the lines).
NOTE: This step is optional.
The table below describes of the possible values:
Name Description Ty p i cal use Abbreviation
Unknown Unspecified Called number in
ou
tgoing calls
u
Subscriber Call number in local
netw
ork
Number called in
incoming calls.
s
National Call number with area
code.
Calling number from
h
ome country.
n
International Call number with
coun
try code and area
code.
Calling number from
abroad.
i
Abbreviated: Unusual. a
Network-
specific
Unusual. x
Call Number Formats Table
6 Click “OK”.
8.13.4 Gatekeeper Interfaces
Gatekeeper (GK) interfaces are channe
ls to the world of Voice over Internet Protocol
(VoIP). If your IP-DECT system needs to communicate with other devices via VoIP, access to
these devices can be configured as a Gatekeeper interface.
Note: No
rmally the Master connects to a PBX via H.323/SIP endpoint registrations. In that
case, no configuration in this section is needed.
These can be different types of equipment:
• Remote PBX
• Ascom VoIP Gateways
• VoIP terminal equipment
• VoIP terminal adapters to connect
analogue terminals or a IPBS
• CGPN out If you want to edit the calling number of outgoing
calls.
• CDPN in If you want to edit the called numbe
r of incoming calls.
• CDPN out If you want to edit the called number of outgoing calls.