User's Manual

TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
121
• Mode Select one of the values below in the Mode drop-down
list. Possible values are:
- Gateway without Registration - connects to the VoIP
interface (gateway) to the configured gatekeeper
without a registration.
- Register as Endpoint - registers as VoIP terminal with
the configured gatekeeper.
- Register as Gateway - registers as VoIP gateway with
the configured gatekeeper.
- Gatekeeper / Registrar - accepts registrations from
other VoIP devices.
- ENUM - registers an ENUM connection with the
relevant interface.
• Gatekeeper address
(primary)
IP adress of the remote VoIP device
• Gatekeeper address
(secondary)
It is important to enter an alternative gatekeeper IP
address, especially when using redundant systems.
• Mask Enter network mask
• Gatekeeper Identifier In general, you can operate without Gatekeeper ID if
only one gatekeeper is operated in your network or if
Gatekeeper discovery is not used.
Authorization Use these settings if log on to another gatekeeper is
needed.
• Password The Password corresponds to the H.235/SIP password
required for logging on to the remote gatekeeper.
• Retype Confirm password
Alias list
• Name Define the H.323/SIP name required to identify yourself
with the gatekeeper. This is the “Long name” on the
PBX Show area.
• Number Usually the gateway only registers with a H.323/SIP
name and not with an E.164 address (i.e. with a
telephone number). Refer to the documentation for the
gatekeeper you want to register.
Media properties For information on these settings see Media Properties
on page 116.
H.323 Interop Tweaks
• No Faststart Enable if the H245 Faststart procedure is to be disabled.
• No H.245 Tunneling A TCP connection of its own is established for the voice
data connection negotiation. Only recommended if
compatibility problems occur with third party products.
• Supress HLC Suppresses the transmission of “high layer
compatibility” information elements on the interface.
• Supress FTY Suppresses the transmission of “facility information
elements” on the interface.