User's Manual

PRELIMINARY
TD 92476GB
2008-06-12/ Ver. PA11
User Manual
Cordless Telephone DT390
36
12 Maintenance
12.1 Charge the Battery
Place the telephone in the desktop charger or in the rack charger. The battery is being
charged when the LED on the telephone is steady orange. When the battery is fully
charged the LED will be green.
An animated battery icon is also shown in the display indicating charging by
starting with its current charge and ending with the full charge. A filled Battery
icon indicates a fully charged battery.
Note: Only use the prescribed chargers for charging.
12.2 Replace the Battery
If the standby time for the cordless telephone becomes too low, the battery should be
replaced by a new one. Please contact your system administrator or your supplier, for
information about new batteries. Replace the battery as described in the illustration
below. The battery is connected to the cordless telephone in such a way that no miss-
contact is possible.
Note: The battery cable should be placed in such a way that it cannot be trapped while
closing the battery lid, see illustration below.
Figure 8. Battery replacement.
IMPORTANT: Do not disconnect the battery unless it needs to be replaced.
1, 4 2 3