User's Manual

TD 92474GB

2008-09-16/ Ver. PB1

User Manual

Cordless Telephone DT690 With Bluetooth

6.4 During a Call

Note: Some of these functions are system dependent. The parameters are set up in the

Portable Device Manager (PDM), see Configuration Manual, Cordless telephone DT690,

TD 92503GB, and Installation and Operational Manual, Portable Device Manager (PDM),

Windows version, TD 92325GB.

6.4.1 Adjust the Volume during a Call

Press the "Volume up" button to increase the volume, and the "Volume down" button to

decrease the volume. The telephone will now store and keep the new volume level. It is

also possible to use the navigation key, and to adjust the volume.

6.4.2 Open Contacts during the Call

Press the soft key "More" during the call, and select "Contacts". Press "Select". See 8.7

Contacts on page 44.

6.4.3 Turn the Microphone on/off during a Call

Press the soft key "More" during the call, and select "Microphone off". Press "Select".

The indicate a silenced microphone. This means that the other part in an ongoing call

cannot hear you. To turn the microphone back on, press the soft key "More" during the

call, and select "Microphone on". Press "Select".

It also possible to turn the microphone off/on by a long press on .

6.4.4 Audio Transfer

To transfer audio between the Bluetooth headset and the telephone’s earpiece.

Press the soft key "More" during the call, and select "Audio transfer"

. Press "Select".

6.4.5 Start a New Call during Conversation

Press the soft key "More" during the call, and select "New Call"

. Press "Select".

Dial the number and press .

6.4.6 Switch between Calls

A new call is started during conversation, the first call is on hold.

Press the soft key "More", and select "Switch"

. Press "Select". This will switch between

the calls.

6.4.7 End a Call

A new call is started during conversation, the first call is on hold.

Press the soft key "More" during the call, and select "End Call"

. Press "Select". This will

end the current call and the previous call is resumed.

1.Visible if Bluetooth connection is active.

2.Visible if defined in the PDM.