User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety Instructions
- 3 Descriptions
- 4 Basic Operation
- 5 Menu Tree
- 6 Calling
- 6.1 Incomming Call
- 6.2 Outgoing Call
- 6.2.1 Pre-Dial
- 6.2.2 Post-Dial
- 6.2.3 Dial Using a Pre-programmed Hot/Soft/Navigation Key or Multifunction Button
- 6.2.4 Dial a Number from the Call list
- 6.2.5 Dial the Sender of a Message
- 6.2.6 Dial a Number from the Local Phonebook
- 6.2.7 Dial a Number from the Company Phonebook
- 6.2.8 Dial a Name from the Central Phonebook
- 6.3 During a Call
- 6.3.1 Adjust the Volume during a Call
- 6.3.2 Open Contacts during the Call
- 6.3.3 Turn the Microphone on/off during a Call
- 6.3.4 Start a New Call during Conversation
- 6.3.5 Switch between Calls
- 6.3.6 End a Call
- 6.3.7 Transfer a Call
- 6.3.8 Transfer to new Call
- 6.3.9 Conference Call
- 6.3.10 Call Back
- 6.3.11 Call Waiting
- 6.3.12 DTMF
- 6.3.13 DECT Info
- 6.4 Loudspeaking Function
- 6.5 Call Diversion
- 6.6 Additional Call Services
- 7 Menu Operations
- 8 Enhanced Messaging
- 9 Advanced Functions
- 10 Operation Notice
- 11 System Handling
- 12 Maintenance
- 13 Troubleshooting
- 14 Related Documents
- 15 Document History
- Index
PRELIMINARY
TD 92643GB
30 September 2010 / Ver. PA4
User Manual
Cordless Telephone 3740 for Avaya
71
No System. The
telephone beeps once a
minute (during max 30
minutes) with a low
tone followed by a high
tone (if enabled, the
vibrator also follows the
beeps).
The telephone is out of coverage
or telephone is defective.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
telephone automatically has
registered into the system.
or
contact system administrator.
SERVICE NEEDED
Parameters corrupt
The telephone is defective. Select reset option on the
middle soft key if available or if
no reset option is available or
fault does not resolve the
telephone needs repair. Note:
Display message only shown in
English.
Enter PIN code The telephone’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via PDM
or do a factory reset via PDM.
Battery low, charge now The battery level is low. Charge the battery while it is in
the telephone, or remove the
battery and replace it, or charge
the battery separately.
Phonebook is not
available at the
moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Voice mail number not
defined
There is no Voice mail number
defined in the telephone.
Define a Voice mail number via
PDM.