User's Manual Part 2

TD 92644GB
26 April 2010/ Ver. B
User Manual
Ascom d81 DECT Handset
80
LED Error Indications
See also chapter LED Indications during Easy Replacement on page 76.
LED is flashing red, quick flash, (100 ms on, 800 ms off)
1) If a third handset, that is another handset than the "old" (the replaced handset) and
"new" (the replacement heandset) handset, is inserted into the charger during Easy
Replacement, this error indication appears. Change to the correct handset.
2) The charger has found that Easy Replacement does not work. Change back to the
"new" handset.
LED is flashing red, long flash (800 ms on, 100 ms off)
Error during Easy Replacement. Both handsets need to be sent for service.
Phonebook is not
available at the
moment.
The phonebook does not
respond, not available at the
moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number via
PDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base station(s);
and/or,
2) Unsupported base station(s).
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in the
base station(s); and/or,
Note: If Ascom’s base
station(s) is used, the software
version must be 3.1.x or
greater.
3) Use supported base
station(s). Ask your supplier.
Not allowed 1) The handset with the shared
phone functionality enabled
cannot be logged in due to
another handset using the
extension (that is, User).
2) The extension (User) does not
exists.
3) The password is not correct.
1) Logout the handset using
the extension.
2) Make sure that you entered
correct extension. If needed,
contact the system
administrator.
3) Make sure that you have
entered correct password. Ask
the system administrator if you
have forgot the password.