User's Manual
Table Of Contents
- 1 Introduction
- 2 Description
- 3 Installation of the Base Station
- 3.1 Base Station Cabling
- 3.2 Install the Base Station
- 3.2.1 Fix the Mounting Bracket to a Wall
- 3.2.2 Fix the Mounting Bracket to a Ceiling
- 3.2.3 Fix the Mounting Bracket to a Pole or Beam
- 3.2.4 Use the Cable Ducts for IPBS1
- 3.2.5 Connect External Antennas (only IPBS2 and DB1)
- 3.2.6 Secure the Cable
- 3.2.7 Pinning
- 3.2.8 Connect the Base Station Cables
- 3.2.9 Mount the Base Station
- 3.3 Power the Base Station
- 4 Installation of the IPBL
- 5 Related Documents
- Document History
- Appendix A. RFP Power Consumption
TD 92989EN
15 October 2014 / Ver. B
Installation Guide
IP-DECT Base Station & IP-DECT Gateway
13
Software
The software in the BS3x0 can be updated by downloading new software without
dis
connecting the equipment. The new software is stored in flash memory. For
information on how to update the software in the BS3x0, see the applicable Installation
and Operation Manual for the BS3x0.
Connectors
• Two 8-pin RJ45 modular jacks for data and powering
• A 6-pin RJ12 modular jack for factory testing
LEDs
Status of LED1 (lower LED) Description
Steady Green Power LED
Status of LED2 (upper LED) Description
Not lit Base station operational and no traffic on the
base station.
Flashing green Fully occupied with traffic.
Steady green Base station operational and traffic on the base
station.
Flashing amber Software is being downloaded to the base station
Steady amber Base station is OK, but not available (self-test, not
initialized, no communication with IPBL)