User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 2
Installation Guide
teleCARE IP
WARNING: The teleCARE IP equipment should not be installed in areas where the air pressure is
below 850 millibar (approximate maximum altitude of 6100ft (2000m).
WARNING: teleCARE IP components, including all handsets, are not intended for use in oxygen
enriched environments.
WARNING: teleCARE IP components, including all handsets, are not intended for use in rooms
where flammable (anesthetic) gases are used.
1.3 teleCARE IP With Speech
The basic installation for a teleCARE IP system with speech is the same as for teleCARE IP without
speech with the exception that room controllers with speech support and a supplementary VoIP
gateway are required. In addition each location where speech is required must have a teleCARE IP
speech module. The speech module can only be used in combination with the teleCARE IP door side
module (NIDM), the bedside module (NIBM), and the pull cord module (NIPC).
1.3.1 Compatible Ascom IM Handsets
teleCARE IP with speech is designed to work with Ascom Interactive Messaging using the Ascom
handsets which support multi-layer interactive messaging. At the time of publication of this document
the Ascom handsets which support multi-layer interactive messaging are:
9d24 / mkII (software 3.71 or higher)
d62 (software 3.0.5 or higher)
d81 (software 2.0.5 or higher)
i75 (software 1.7.7 or higher)
1.3.2 System Overview teleCARE IP with Speech
The following illustration shows a typical example of a teleCARE IP speech system. The options and
system components depend on the specific project requirements.
Figure 1. System overview teleCARE IP with speech
0 0
Backbone
teleCARE IP
Room
Buses
Admin PC
with the
System Manager
GUI
SwitchSwitchSwitch
System
Manager
Room
Controllers
Room
Controllers
teleCARE IP
Room
Buses
Innovaphone
IP 302
IP DECT / VoIP
VoIP Trunk
IMS
ESS
Ascom
Messaging
Products
IMS
ESS
Asc
om
Messa
g
in
g
Pro
d
uct
s
NISM
NIRC NIRC NIRC NIRC