User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 115
Installation Guide
teleCARE IP
Note:
• The equipment that is connected to this interface is not considered to be part pf the system
configuration unless the equipment complies with ANSI/UL 2560 standard for Emergency Call
Systems for Assisted Living and Independent Living Facilities.
• The Television Interface Module provides electrical isolation between the Television and the
teleCARE IP Emergency Call System.
• Television audio in teleCARE IP requires the bedside module NIBM2. For details of the NIBM2 refer
to chapter 6.5“Bedside Module (NIBM2)” on page 72.
• The 4 pole connector terminals must be ordered separately.
6.18 Sunblind Control Module
Figure 154. Sunblind Control Module
The Sunblind Control Module is a passive device on the teleCARE IP room bus. It has two heavy duty
relays with normally open contacts to control the sunblind motor.
The sunblind control module is compatible with the bedside module NIBM2 and the medical rail
socket NIMS2. It is used in combination with the NIPH3-A7A and NIPH3-AES handsets to control the
up and down motors of sunblinds.