User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 39
Installation Guide
teleCARE IP
The room bus wires should be guided around sides of the room controller housing and held in place
by the wire holding clip, as shown in the following illustration:
Figure 39. Connecting the room bus
The connection point on the room controller circuit board for the room bus of the NIRC3 is shown in
section 5.3.5 on page 37
Figure 40. NIRC3 - Connecting the room bus
Use the Wire
Holding Clip
Use the Wire
Holding Clip
NIRC3