User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 29
Installation Guide
teleCARE IP
5.3.3 IP Room Controller (NIRC) Printed Circuit Board Back View
Figure 23. NIRC printed circuit board back view
On the back of the printed circuit board there are four sets of through-board connection holes for LED
lamp boards. Details of for connecting the LED lamp boards are given in section 5.6, LED Lamp
Boards, page 43.
Also on the back of the IP room controller printed circuit board there is a set of three identical MAC
address labels and a product label which includes the part number and serial number.
The three MAC labels are self-adhesive and can be removed from the printed circuit board. One of the
labels should be left on the room controller printed circuit board. The other two can be removed and
one can be stuck on the cover of the room controller, so the board can be identified without opening
the room controller. The other can be used in a list of all room controller locations, for example, for
administration purposes.
Product label with part number
and serial number
Through-Board Connection
Holes for the LED Lamp
MAC address label