User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 51
Installation Guide
teleCARE IP
5.7.2 Removing the Corridor Lamp Printed Circuit Board
To remove the circuit board from the housing, press the holding clip outwards until it releases the
circuit board, as shown in the following illustration:
Figure 59. Removing the circuit board from the housing
With the printed circuit board released from the holding clip, partly rotate the circuit board and
remove it from the housing.
5.7.3 Corridor Lamp Housing
The corridor lamp has the same housing as used for the IP room controller which is designed to be
surface mounted. Refer to section 5.2.8, Room Controller Housing on page 24 for details of mounting