User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 40
Installation Guide
teleCARE IP
5.5.4 Connecting Multiple Room Buses
The IP room controller supports three room buses and each has a 4-pole connection terminal which is
wired as described in section 5.4.1 on page 31. The connection points on the room controller PCB
for the room buses are shown in section 5.3.2 on page 28.
The room bus wires should be guided around the sides of the room controller housing and held in
place by the wire holding clip, as shown in the following illustration:
Figure 41. Connecting multiple room buses
The connection points on the room controller PCB for the room buses of the NIRC3 are shown in
section 5.3.5 on page 37.
Figure 42. NIRC3 - Connecting multiple room buses
Use the Wire
Holding Clips
Use the Wire
Holding Clips
NIRC3