User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 41
Installation Guide
teleCARE IP
5.5.5 Connecting LAN Cable
The LAN cable has an RJ45 plug which connects to the socket on the room controller printed circuit
board shown in section 5.3.2 on page 28. The LAN cable should not be guided through the wiring
clips inside the room controller housing. It should be plugged directly into the RJ45 connector on the
printed circuit board with enough cable to avoid straining the LAN connection.
Figure 43. Connecting the LAN cable
RJ45 LAN
Connector
(Do not use
the wire
holding clips)