User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 24
Installation Guide
teleCARE IP
5.2.8 Room Controller Housing
The room controller housing is designed to be surface mounted. It can be mounted over a back box or
fixed directly on to a wall surface. The same housing is used for the IP room controller with LED lamps
and with blank cover and for the corridor lamp.
Figure 16. Room controller housing
5.2.9 Mounting the Housing over a Back Box
To mount the housing over a back box, start by partially unscrewing the fixing screws (1) in the back
box so that they extend at least 0.2in (5mm) outside the wall surface.
Figure 17. Lining up the housing with a back box