User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 87
Installation Guide
teleCARE IP
IMPORTANT: Together with the passive toilet cancel module a passive pull cord module
which contains the line break detection circuitry must be installed. The passive pull cord
module must be connected at the end of the passive bus.
The Passive Toilet Cancel Module requires a single backplate which must be ordered separately. The
backplate enables this switch module to be mounted over different types of back boxes. Alternatively,
a spacer with installation kit is available for surface mounting the switch module.
6.11.1 Passive Toilet Cancel Module (Passive) Electrical Connections
This toilet cancel module is a “passive peripheral” therefore it must be connected to the passive bus of
the linked door side module by the 4-pole passive bus connector (see 6.4.1, 4-Pole Connector
Terminal on page 65).
Figure 110. Passive toilet cancel module electrical connections
Note: The 4-pole connector terminal for the passive bus is not supplied with the switch
module. It is available as an accessory and must be ordered separately.
6.12 Pull Cord Module (NIPC2) Active and Passive
The NIPC2 Pull Cord Modules are designed for use in the teleCARE IP system. They are IP44 splash
proof and therefore suitable for use in rooms with showers, baths and in similar wet areas. They are
available as an “active” module and a “passive” module.
4-Pole
Connector
for the
Passive Bus