User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 85
Installation Guide
teleCARE IP
6.9.1 Toilet Cancel Module (Active) Electrical Connections
The toilet cancel module is an “active peripheral” therefore it must be connected to one of the three
room buses of a teleCARE IP room controller by the 4-pole room bus connector (see 6.4.1, 4-Pole
Connector Terminal on page 65).
The toilet cancel module also has a 4-pole connector for the passive bus to which a passive pull-cord
call module can be connected (see 6.10.1, Pull Cord Module (Passive) Electrical Connections on page
86).
Figure 106. Toilet cancel module electrical connections
Note: The 4-pole connector terminals required for the room bus and the passive bus must
be ordered separately as accessories.
6.10 Pull Cord Module - Passive (NIPC-XXP)
Figure 107. Passive pull cord module 3 buttons
4-Pole Connector
for Room Bus
4-Pole Connector
for the Passive Bus