System Description

TD 93025US
9 May 2019 / Ver. I 23
System Description
teleCARE IP
6 Peripherals
6.1 General
A peripheral is an end user device that can be part of teleCARE IP System. This section describes the
following peripheral devices:
• “Bedside Module (NIBM2)” (details on page 25)
• “Doorside Module (NIDM)” (details on page 26)
• “Pull Cord Module (NIPC)” (details on page 26)
• “Toilet Cancel Module (NITC)” (details on page 27)
• “Pull Cord Module - Passive (NIPC)” (details on page 27)
• “Toilet Cancel Module - Passive (NITC)” (details on page 28)
• “Pull Cord Module - IP44 (NIPC2)” (details on page 29)
• “Medical Rail Module (NIMS2)” (details on page 30)
• “Duty Selector (NIDS)” (details on page 31)
• “Card Reader Module (NICR)” (details on page 32)
• “Speech Module (NISP)” (details on page 33)
• “Acoustic Monitoring” (details on page 34)
• “Room Display (NIRD)” (details on page 35)
• “Television Interface Module” (details on page 38)
• “Sunblind Control Module” (details on page 39)
6.2 Switch Modules
Switch modules are available in a three button, two button, one button, or blank layout. The button
colors of a three button switch module are red, yellow and green. The button colors of a two button
switch module are yellow and green. The button color of a one button switch module is red. A blank
module has no buttons. All the buttons are assigned a reassurance LED which permanently emits a
low intensity light for night-time locating and identification in the dark.
The function of the buttons on a teleCARE IP switch module is freely programmable using the
teleCARE IP system manager. However, in a typical installation the red, green and yellow buttons are
respectively used for making emergency calls, reporting attendant presence and calling for assistance.
Note: For cleaning instructions, see chapter C‚ ‘Cleaning the Switch Modules’ on page 110.