System Description

TD 93025US
9 May 2019 / Ver. I 29
System Description
teleCARE IP
6.9 Pull Cord Module - IP44 (NIPC2)
The NIPC2 Pull Cord Module is designed for use in the teleCARE IP system. It is IP44 splash proof and
therefore suitable for use in rooms with showers or baths and similar wet areas. It is available as an
“active” module and a “passive” module.
The NIPC2 is available in gray or white and has a pull cord of length 2 meter with two plastic balls. The
top ball acts as a safety break by splitting in half when the cord is pulled with excessive force.
Figure 22. NIPC2 Pull cord module (exploded/assembled)
The active version of the NIPC2 is connected to one of the room buses of the IP Room Controller. It
has a 4-pin connector for the connection of the room bus. The room bus address is set by DIP
switches.
The passive version must be connected to the passive bus connector of a doorside module or of an
active toilet cancel module. It has a 4-pin connector for the connection of the passive bus.
The NIPC2 Pull Cord Module includes a special backplate with two urethane foam gaskets which give
the NIPC2 splash water protection to IP44 standard. In order to attain the IP44 splash water protection
the backplate must be mounted on a smooth and flat wall surface using the four corner holes in the
backplate.
The NIPC2 module is fixed on the backplate by two latches and two screws through the cover plate.
IMPORTANT: The NIPC2 can only be mounted on the supplied IP44 backplate. It is not
compatible with the standard teleCARE switch module backplate and it is not compatible
with the teleCARE surface mounting spacer.