User manual
20
www.ashdownmusic.com www.ashdownmusic.com
21
VU
Ashdown Ampliers reserve the right to change specications without notice. E & O E. All contents © Ashdown 2012.
USER MANUAL
VALVE
CTM-300
FACILITIES AND CONTROLS (NOTE THAT THESE VARY ACCORDING TO THE MODEL)
INPUTS
There are two instrument inputs marked LOW and HIGH. The LOW input is highly sensitivity and also high impedance
to suit the output from PASSIVE (Low Output) basses - The HIGH input is low sensitivity and lower impedance to suit
the output from ACTIVE (High Output) basses. Plugging an active (High Output) bass into the LOW input will overload
the input, creating a fatter, warmer and more distorted sound. Experiment by plugging your bass into either input to
achieve the desired sound. On models with a single input this will be suitable for both Passive and Active basses.
EFFECTS SEND AND RETURN
These 1/4” jack sockets should be used to connect to an external eects device or pedal board. The EFFECTS SEND
output should connect to the INPUT of the eects unit, and the output of the eects unit should be connected to the
EFFECTS RETURN input Note that the signal level is at instrument level so this loop is suitable for eects pedals.
EQ CONTROLS
Use the MIDDLE, BASS and TREBLE controls to eect the overall tone of the sound.
MID SHIFT
Causes the MIDDLE control to operate at dierent points in the frequency spectrum dependant on the button being
either in or out.
BASS SHIFT
Causes the Bass control to operate at dierent points in the frequency spectrum dependant on the button being
either in or out.
BRIGHT
Adds an overall brightness to the sound when in the up position. (Note: The BRIGHT switch is not eective when the
GAIN control is set to full).
Ashdown Ampliers reserve the right to change specications without notice. E & O E. All contents © Ashdown 2012.
CTM-100
MELLOW
Softens the overall tone slightly
GAIN
This controls the level of the signal sent to the MASTER section. To achieve a cleaner sound, turn the GAIN control
down and the MASTER up. To achieve a richer, more distorted sound, turn the GAIN control up and the MASTER
down.
MASTER
This controls the overall output volume of the amplier.
MUTE
In the in position, this switch mutes the out put of the amplier (useful for tuning, etc.).
PRE/POST
This switch determines whether the signal from the DI OUTPUT (see Rear Panel Facilities) is taken before/PRE the
EQ section (down position) or after/POST (up position).
VU METER
The VU meter provides a visual indication of the output level of the amplier. It also acts as a bias meter, ( not on
CTM15 ) please see the following page for more details.