Installation Guide

WARNING: BEFORE INSTALLING IN A SOLID-FUEL BURNING FIREPLACE, THE CHIMNEY FLUE AND

FIREBOX MUST BE CLEANED OF SOOT, CREOSOTE, ASHES AND LOOSE PAINT BY A QUALIFIED

CHIMNEY CLEANER.

CAUTION: ANY OUTSIDE AIR DUCTS AND/OR ASH DUMPS IN THE FIREPLACE SHALL BE

PERMANENTLY CLOSED AT TIME OF APPLIANCE INSTALLATION.

WARNING: SOLID-FUELS SHALL NOT BE BURNED IN A FIREPLACE IN WHICH AN UNVENTED

ROOM HEATER IS INSTALLED.

INSERT KEYS BEHIND FLANGE OF TRIM AS

SHOWN. BLANK CORNER KEY MUST BE IN-

STALLED FIRST. INSERT SECOND KEY. ADJUST

TRIM AND TIGHTEN SET SCREWS.

INSERT FIREPLACE FACADE INSTALLATION

1. Position stove in ﬁ replace. Align facade panels with ﬁ replace and top of stove. The panels should be ﬂ at

against the ﬁ replace and standing vertical.

Notes: The facade must be installed before unit is set into its ﬁ nal position.

2. Mark the location of the facade panels along the top of the stove with a pencil. The mark will be used

to realign the panels later.

3. Slide stove out of ﬁ replace far enough to be able to work behind facade panels.

4. Realign the ﬁ rst side panel with the mark made previously.

5. Using the predrilled holes in the facade panel as a guide; mark and drill holes for the self tapping screws

used to mount the facade panel. See illustration

on right.

Note: Align the mounting screws with the center of

the predrilled holes to allow for adjustment.

6. Repeat steps 4 and 5 for the other side panel.

7. Attach side panel trim as shown. See illustration

on right.

8. Ensure venting is attached properly.

9. Align the top panel with the side panels and screw

each side together use self tapping screws to

attach the surround top to the stove.

10. Attach top panel trim.

Note: Stove and facade panels should realign

with ﬁ replace to allow the panels to be ﬂ at against

ﬁ replace and standing vertically